How to ensure the cutting speed and accuracy of the laser cutting machine

How to debug the laser cutting machine to make it cut faster and better? In fact, the laser cutting machine is like a car. It needs to be tested and debugged before leaving the factory. It needs to be maintained during use to keep the equipment in a relatively good operating condition. The laser cutting machine has more components, and some parts have a shorter maintenance period. For example, protective lenses need to be updated frequently according to the frequency of cutting and working hours.
   一. Adjust the machine assembly to improve the cutting effect of the machine.
  1. Rails: When installing the rails, they must be parallel. If the rails are not parallel, there will be resistance when the machine runs, and the cut workpieces will have sawtooth trimming. Therefore, the Y-axis rails must be parallel.
  2. Crossbeam and coupling: During the installation of the crossbeam and coupling of the machine, if the screw is not locked, or the lock is oblique or loose, it will affect the cutting effect of the laser cutting machine. Therefore, the installation quality and accuracy of the parts must be guaranteed.


   二. Debug the parameters of the laser machine to improve the cutting speed of the machine.
   During the cutting process, the machine parameters need to be adjusted step by step. Generally, if the machine parameters are not adjusted well, the cutting speed and effect will be affected to a certain extent. When leaving the factory, each laser cutting machine sets and saves its parameters according to the power size, cutting material and thickness. Later, it can be adjusted according to the needs of users. Generally, pay attention to the following points when setting parameters:
   1. Initial speed: As the name suggests, this setting is the speed at which the machine starts. The initial speed is not as fast as possible. In fact, if the speed is too fast, it may cause the machine to shake very badly at the beginning.

  1. Acceleration: When the machine is in production, there is an acceleration process from the initial speed to the normal cutting. Similarly, there will be a deceleration process when preparing to end the cutting. If the acceleration is too low, it will cause The cutting speed of the machine slows down.
       If you have laser cutting machine product requirements, you can directly consult our online customer service, more product knowledge will continue to be updated for you.

Leave a Comment

Your email address will not be published. Required fields are marked *