What happened to the deformation of the finished fiber laser cutting machine?

Fiber laser cutting machines can often complete tasks very well when processing metal materials. The cut metal materials are very good in terms of cutting surface and accuracy. However, after some people use fiber laser cutting machines to process metal materials, the processed products have deformation problems, which makes many people very distressed. So what happened to the deformation of the finished fiber laser cutting machine? How to solve it? After reading the content below, you will understand!

fiber laser cutting samples

What happened to the deformation of the finished fiber laser cutting machine?

  1. The fiber laser cutting machine itself is a large-scale cutting equipment composed of multiple components. When the core component fails, it is normal to affect the processing quality of the metal material. This only needs to be repaired in time.
  2. The fiber laser cutting machine does not guarantee that the processed workpiece is not deformed at all, but compared to other cutting equipment, the material deformation is much smaller. If there are some very subtle deformations, it is obviously unreasonable to blame the equipment itself. Of.

3. The material and thickness of the metal material are inconsistent with the equipment. The material and thickness of the material are often the biggest cause of deformation. Some materials may be highly reflective. Fiber laser cutting machines generally need to be processed when cutting this material. Cutting without processing will be affected to a certain extent, and the thickness does not match the power of the equipment, which further affects the machine. Processing quality, these factors will cause the material itself to be unevenly heated and deformed.

4. The equipment is not properly debugged; although the fiber laser cutting machine is very technical, it is necessary to arrange for professionals to debug the entire machine before starting up. Many customers often ignore this point and rush if they are not properly debugged. The cutting effect will of course be affected when the machine is turned on.

The above is the main content of the deformation of the finished fiber laser cutting machine. In fact, this situation may also be caused by irregular operation. We don’t have to panic when facing this situation, just check whether there is a problem with the detection machine, whether the cutting points of metal materials are followed, and whether the cutting operation is standardized!

Leave a Comment

Your email address will not be published. Required fields are marked *