What methods can be used to reduce the loss of fiber laser cutting machine?

What methods can be used to reduce the loss of fiber laser cutting machine?

In our work, when using a fiber laser cutting machine, under the premise of ensuring its cutting quality, we will do everything possible to reduce its loss. Is there any way to reduce its loss?

When the cutting machine is needed for work, we must first push the beam before starting the machine, try to move it back and forth, and the trolley can move left and right without abnormal noise before it can be powered on. After finishing the work of the day, clean up the materials produced on the day in the machine and the waste residues generated. This can protect the motion system of the machine and prevent it from being damaged by foreign objects. Clean up its moving parts to keep the machine in good working condition. The specific methods are as follows:

  1. Put a little lubricating oil on the screws, including the screws on the laser tube support and the first reflector, which can facilitate the disassembly and assembly during maintenance. Note: Do not add lubricating oil to timing belts, drag chains, air pipes, motors, sensors, lenses, and wires.
  2. No items can be placed in the machine to avoid unnecessary damage to the machine.
  3. Clean with cotton cloth: dust and foreign matter on the metal oil tanker, metal shaft, sliding block and linear guide, and then add lubricating oil, and carry out the reciprocating motion of the empty line.

Although the laser cutting machine covers a wide range, but its main direction is metal cutting, and can complete superior work. The diameter of the laser beam of the laser cutting machine can reach 0.1 mm, and the cutting diameter on metal materials can reach about 0.2 mm. Therefore, the cutting pattern is very accurate. It not only improves the artistic taste and technical content of sheet metal processing. , But also increased profit margins. Therefore, workers must carry out some training before operation, care when using, and standardize the operation, so that the equipment can better serve everyone.

Leave a Comment

Your email address will not be published. Required fields are marked *